Copyright

Industrial Network Design & Architecture Chapter Exam

Exam Instructions:

Choose your answers to the questions and click 'Next' to see the next set of questions. You can skip questions if you would like and come back to them later with the yellow "Go To First Skipped Question" button. When you have completed the practice exam, a green submit button will appear. Click it to see your results. Good luck!

Page 1

Question 1 1. Which category of smart devices has the ability to measure an array of metrics such as battery voltage, engine speed, temperatures, water and air pressure, and voltage?

Question 2 2. To ensure quality, many production plants in the food and beverage industry utilize _____ to detect subpar end products.

Question 3 3. Which of the following use cases for industrial smart devices involves GPS locators?

Question 4 4. Quenching of Water tanks is the application of PLC in _____.

Question 5 5. Communication with internal components and programming terminals is established in _____ step of PLC working.

Page 2

Question 6 6. Glass industries use analog mode of PLCs for _____.

Question 7 7. Switch sensor are used to (a)_____ the limit switch, proximity sensor, and other (b)_____.

Question 8 8. What are the International Standards Organization and Open Systems Interconnection (OSI) basic reference models?

Question 9 9. What is the purpose of a safety bus?

Question 10 10. Which of the following terms refers to those systems tasked with the operational safety of the production process?

Page 3

Question 11 11. Which of the following occurs after sensors send information to the logic system?

Question 12 12. Which of the following best describes the final control element in an SIS?

Question 13 13. What does a logical network topology describe?

Question 14 14. Which of the following is NOT a type of physical network topology?

Question 15 15. What is a hybrid topology constructed of?

Page 4

Question 16 16. Which type of signal is suitable for short-range communication?

Question 17 17. Which frequency range is suitable for satellite communication?

Question 18 18. Wireless transmission happens when wireless equipment converts _____.

Question 19 19. The tree network topology is a special type of _____ topology.

Question 20 20. Which network topology uses a central hub or controller?

Page 5

Question 21 21. Consider a number of computers are in a network, and one computer crashes. In which of the following network topologies will the entire network also go down?

Question 22 22. In a _____ topology network, all the devices are connected back to a central hub or switch.

Question 23 23. A wireless network for Internet access in a large building is typically connected in a _____ topology.

Question 24 24. Ethernet is an example of which kind of signal topology?

Question 25 25. Environmental conditions may cause what problems in industrial network?

Page 6

Question 26 26. What are the two types of Interoperability and what are the differences between them.

Question 27 27. Bandwidth is the _____ of data transfer or the network traffic that can be supported. The more the bandwidth, the _____ the network will be.

Question 28 28. Which of the following components found in human-machine interfaces allows for an electrical circuit to be toggled on or off?

Question 29 29. Which of the following is a function discussed in this lesson for HMIs used in the food processing industry?

Question 30 30. Which of the following best defines a human-machine interface?

Industrial Network Design & Architecture Chapter Exam Instructions

Choose your answers to the questions and click 'Next' to see the next set of questions. You can skip questions if you would like and come back to them later with the yellow "Go To First Skipped Question" button. When you have completed the practice exam, a green submit button will appear. Click it to see your results. Good luck!

Computer Science 330: Critical Infrastructure Security  /  Computer Science Courses
Support